Description
Brief introduction
   The DRV8825 stepper motor driver carrier board TI DRV8825 micro bipolar stepper motor drive is a breakthrough. The module has a pinout and interface with our A4988 stepper motor driver carrier is almost the same, so it can be used as a better performance of the pull-down menu board replacement in many applications. DRV8825 features an adjustable current limit, overcurrent and overtemperature protection, six micro-resolution (down 1/32-step). It uses 8.2 – 45 V, can provide up to about 1.5 per phase no heat sink or forced air flow (rated up to 2.2 per volume sufficient additional cooling).
Product Features
- A simple steps and direction control interface
- Six different steps resolutions: full step, half step, 1/4-step1/8-step1/16-step, 1/32-step
- CAN interface directly with 3.3 V and 5 V systems
- Over-temperature thermal shutdown, overcurrent shutdown, undervoltage lockout
- short to ground short circuit load protection
- 4 Layer 2 oz copper PCB, in order to improve heat dissipation
- Exposed solder ground below the bottom of the driver IC on the printed circuit board pad
- Module size, pin and interface matching A4988 stepper motor driver operators in many ways
- Adjustable current control lets you set a potentiometer, which lets you use the stepper motor’s rated voltage or more, in order to achieve a higher rate of maximum output current step
- Intelligent chopping control automatically selects the correct current decay mode (fast decay or slow decay)
- Maximum 45 V supply voltage
- Built-in voltage regulator (the need for any external logic supply voltage)
Reviews
There are no reviews yet.